During this meeting, the group got the 3D printed parts designed. These parts are used to hold the motor in place so it can rotate in the holder. The hole was the wrong size due to a software issue, but the opening was shaved down so it was able to fit the motor. The hole used to hold the rotating piece was also too big, so it was necessary to figure out a way to shrink the hole down from its current size.
The final report was edited this week based on corrections from other readers. It was lacking definitions and results. The results were added to the report to reflect the experiments run on the system. Two experiments were run to make sure the power was flowing the way suspected and needed. The second experiment was used to make sure the servos were connected through the arduino and could be moved, as that is part of the plan.
No comments:
Post a Comment